What are the characteristics of thermal oil boilers?

What are the characteristics of thermal oil boilers?

Thermal oil boiler has the characteristics of low voltage, continuous high temperature, safety, high efficiency, environmental protection and energy saving. With perfect work control and safety monitoring device, can control the operating temperature.

The coal used in the operation of the thermal oil furnace needs to be ignited in the chain furnace, so as to obtain economic benefits, and it is crucial to maintain the stability of the ignition situation. Providing the right amount of air is a relatively stable standard for ignition, but too much gas, households reduce the temperature in the furnace, affecting the steady improvement of the ignition of the smoke exhaust system loss, in fact, less gas, will also make the coal burning is not deep, improve the mechanical ignition loss, so it should be based on the flammability of raw coal, exhaust air volume with each other is essential, along the length and orientation of the grate plate, the selection of air distribution by segment, And along the overall wide orientation of the furnace, it is necessary to keep the surface surface of the grate wind uniform.

The structure is reasonable, the supporting facilities are complete, the assembly cycle time is short, the operation and maintenance are convenient, which is conducive to the boiler layout. Because the electric heater organic heat carrier furnace uses the cutting-edge explosion-proof structure, it can be used for the explosion-proof type in the factory II zone.

The relative density of the heating tube is determined by the relative density of the filling tube, the relative density of the shrinking tube or the plastic tube. The higher the relative density value is, the higher the electrothermal effect is, and conversely, the lower it is. The selection of raw materials with good heat transfer performance will improve the electric heating effect and the service life of the heating tube.

Safety protection: It can be shown in the field and transmitted to the control box by the instrument panel, the user can set the ambient temperature standard value, and can be interlocked with the fan, complete automatic adjustment operation, and continue to report high temperature. Heat transfer oil inlet temperature display: can be shown in the field and remote water meter to the control box through the instrument panel display.

The heat transfer oil boiler completes the low liquid level alarm of the expansion tank, and immediately prompts the fireman to refuel the system to ensure the reliable operation of the boiler system. The starting speed of the grate is controlled by the knob and can be adjusted anytime and anywhere according to the actual situation.

Which aspects should be paid attention to when applying thermal oil boiler?

1, heat transfer oil boiler application of large heat transfer oil as heat transfer oil, gas heat transfer oil boiler, the system should be equipped with expansion tank, detection instrument and control system.

2, in the use of the process should be carefully checked, resolutely eliminate water, acid, alkali and melting point boiling point matter leakage into the application system, the system should be installed filtration system, to avoid impurities into, to ensure the purity of the product oil.

3, when the heat transfer oil boiler is delivered, during the operation period, first run the gasoline pump of the circulation system, after half an hour of operation, and then start to raise the temperature, the first use should be slow to raise the temperature, an hour to raise the temperature of about 20℃, when the temperature is raised to 180~200℃, and then heat insulation for a period of time, you can invest in normal start.

4, after six months of application, it should be oil analysis, long-term use, if found poor heat conduction, or other abnormal phenomena, to solve the oil analysis, according to the analysis data to determine the addition or replacement.

5, heat transfer oil boiler in order to ensure the stable service life and heat transfer of heat transfer oil, prohibited application.